ASP-ABF100J

Descarga del catálogo

Automatic Button Feeder

  • CAR Buy it now
Choose model

Choose Model

Specification

General

Optional

Remark:  

Standard: Professional table, All Set of Button Presser Foot ,Small/Big Button Serrarted Plate and Bottom Plate, 12 Sets of Standard Button Carrier.
Option: 3-Holed of Button Carrier,Button Spacer,Button Spacer with Laser Light.

 *The definition of Button Size:
Extra small button size is Φ8~10mm, small button size is Φ10~20mm, and large button size is Φ20 ~ 26 mm. Basically, Button clamp of machine head is applied for Φ8~26mm, but that sewing extra/ large button size are depend on its thickness and convexity.
 

Button sewing machine with auto button feeder enhances 300% efficiency of button sewing.

Cycle Time: 2.2 Sec./Button; 13,090 Buttons/8 Hr

BUTTON CARRIER MODULE

Modularized button carrier is for different button size and replacement.

PANEL

User friendly interface, all sewing  parameters are clearly shown.

SENSOR SIGNAL DETECT

Checking the sensors detecting by A02 function of operation panel.

FLIP MECHANISM

Flip mechanism enhance the accuracy of ø16mm up button by auto air-blow.

SMART SENSOR OF BUTTON CLAMP

Button clamp can detect the button position and avoid sewing without button.

BUTTON CHANNEL ADJUSTMENT

Channel adjustment is controlled by stepping motor accurately .

DISCHARGING

Press the key and then remove all the buttons in the channel.

ELECTRONIC AUTOMATIC MEASUREMENT OF BUTTON SIZE

Accurate, Ultrafast, adjusting different button in a short time.

BUTTON CLAMP OF MACHINE HEAD

Button clamp is suitable for variety button size, the clamp can be used in different button size and no further adjustment needed. 

SPECIFICATION OF BUTTON

Codes of PartsX＋0.05
  －0.05		D＋0.05
  －0.05		Button
Holes
ABF1182.21.04
ABF1192.21.02
ABF1202.41.24
ABF1212.41.22
ABF1222.81.24
ABF1232.81.22
ABF1243.21.24
ABF1253.21.22
ABF1263.61.24
ABF1273.61.22
ABF2692.61.24
ABF2702.61.22
ASO-ABF100J.100B-07

BUTTON SHAPE

Available Shape of Button
Two sides must be have obvious differences to make sure that the machine can differentiate the front & reverse side of the buttons.The convex / concave must above 1.2mm height difference.
Unavailable Shape of Button
The machine can’t identify the button when both sides are similar without obvious
differences.